![]() ![]() The deadbolt latch and strike are misaligned, causing the latch to bind.Īdjust the tab of the lower strike (for your knob or lever) to help align the upper latch and strike so that the latch bolt enters the strike when the door is locked.Replace with the new tapered latch that came with the lock and reinstall the lock. Remove the lock from the door, including the old latch. If the latch being used is from an older lock, it will likely not have a tapered latch bolt. SmartCode deadbolts require a tapered latch bolt for ease of operation. YES - Door handing process was successful!ĭisassemble the lock, and reinstall it without the adapter ring on the exterior side of the door. NO - Remove battery pack, wait 15 seconds, then attempt the process again. Did the latch bolt retract and extend on its own when the battery pack was installed? Note: Latch bolt will only retract half way.Press and HOLD the Lock button while installing battery pack. Hold button until the latch bolt starts moving on its own.Remove interior cover and battery pack.This step will teach your lock the orientation of your door and is crucial to lock operation. The door handing process was not executed during installation.If you did not receive any keys with the lock you can take the cylinder to your local home improvement store and have the cylinder reset to a random cut Kwikset key.On my Smartcode Deadbolt, the lock beeps, the keypad flashes red, and the door cannot lock. Insert new key & turn 1/2 turn counter-clockwise. Insert functioning key & turn 1/4 turn clockwise.Ģ. Steps to re-keying Smart Key units (Note: You must have your Functioning Key and Learn Tool for this to work).ġ. After the hour has passed, you may re-enter the batteries. To perform a hard reset of the unit, remove all four batteries and leave them out for 1 hour. If your old code still remains in the unit, you will need to perform a hard reset of the unit. Press the PROGRAM button twice, enter the same or a new code and then press the LOCK button once. Press the PROGRAM button once, enter your new 4 - 8 digit code and then press the LOCK button.Ģ. Manually put the bolt in the extended (lock) position. This will also remove any previous codes stored in the Powerbolt's memory.ġ. The steps below are to change your access code to a new code. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |